ElementRef

Pall · Supralon · inline line

HCA064FRP8Z filter element: specifications & equivalents

The HCA064FRP8Z is a Pall inline-line hydraulic filter element, built with glassfiber media, rated at 5 µm absolute (βx(c)≥2000). Verify against the current manufacturer data sheet before ordering.

Filtration rating 5 µm abs.
Beta rating β x(c)≥2000
Media glassfiber
Line type inline
Catalog verified. Parameters extracted from the manufacturer’s electronic catalog / official interchange document and checked 2026-10-01. Confidence score 0.90.

Supralon listing prints removal rating (µm) and nominal length only — no OD, ID, collapse or bypass data. Verify envelope dimensions against the current Pall data sheet before ordering.

Specification table

ParameterValue
Filter type inline line
Media glassfiber
Filtration rating 5 µm
Rating basis absolute
Beta ratio βx(c)≥2000
Length 203.2 mm
Nominal length code 8 in
Integral bypass valve none (housing/valve-dependent)
Seal material fluorocarbon
Manufacturer part no. HCA064FRP8Z
Source catalog Pall Corporation (Danaher): Pall Supralon™ Lube and Hydraulic Filter Elements
Last verified2026-10-01

Sources: Pall Corporation (Danaher) — Pall Supralon™ Lube and Hydraulic Filter Elements — accessed 2026-10-01.

Pall® and all model designations are trademarks of their respective owners, used here for identification only — ElementRef is an independent reference site, not an authorized Pall distributor.

Dimensions & series range

Overall length203.2 mm (8.000 in)
Nominal length code8 inches

Cross references & equivalents

No catalog-verified cross references yet. This model is in the manual verification queue — request a verified equivalent.

Interchange levels: full catalog-confirmed drop-in · partial verify parameters · verify manual confirmation required. Links resolve to the equivalent model's specification page where available.

How the HCA064FRP8Z model number is decoded

  • HCA064FRP8ZPall Supralon replacement element part number per the Pall Supralon product listing.

Typical equipment & applications

  • Hydraulic and lube-oil replacement element per Pall Supralon™ product listing.

Selection pitfalls — read before you substitute

  • “10 µm nominal” and “12 µm at β1000” can describe the very same media — one is reported at β≥200, the other at β≥1000 per ISO 16889. Compare ratings at the same Beta test point, not just the printed micron number.
  • Nitrile (NBR) seals are standard for mineral hydraulic oil but fail early in some phosphate-ester fluids and at sustained high temperature; verify seal compound against the fluid data sheet (fluorocarbon/Viton executions may be required).
  • Fine 5 µm media loads faster and runs at a higher cold Δp than coarser grades — only downgrade cleanliness targets if the system ISO 4406 code allows it.
  • End-cap geometry and the number/position of O-rings block interchange even when OD and length match — visually compare end caps before fitting, especially with aftermarket cartridges.

Frequently asked questions

What micron rating does HCA064FRP8Z use?
This element is rated 5 µm absolute — βx(c)≥2000. Always compare Beta ratings at the same test point: two brands may print different micron numbers for the same physical grade.
What replaces the HCA064FRP8Z filter element?
Cross references are being verified for this model — use the inquiry form and the engineering desk will confirm equivalents.
How do I read the HCA064FRP8Z part number?
See the designation decoder above: each segment of HCA064FRP8Z encodes size, line type, filtration grade and media/collapse execution.
Is a same-envelope aftermarket element always a drop-in replacement?
No. Matching OD and length only proves the cartridge fits the bowl. End-cap style, seal compound, micron/Beta rating, collapse pressure and bypass configuration must also match; the table above tags every equivalent as full, partial or verify for exactly this reason.
How often should a hydraulic return-line element be replaced?
Replace at the housing manufacturer’s recommended differential-pressure setting (commonly signalled by a clogging indicator), or on a time-based service interval when no indicator is fitted — never wait for bypass to open continuously, because unfiltered oil then reaches the valves.

Other models in the Supralon series

All 1523 →
HC0008FRP11Z 5 µm HC0012FRT8Z 25 µm HC0014FRS6Z 12 µm HC0015FRT4IZ 25 µm HC0030FRN16EZ 7 µm HC0030FRN3Z HC0030FRP3Z 5 µm HC0030FRS3HCN 12 µm HC0030FRS3Z HC0046FRT10Z 25 µm

Reviewed & verified by the ElementRef engineering desk against Pall Corporation (Danaher) on 2026-10-01. Read our editorial & correction policy.